Non-contact Ultrasonic Water Level Ultrasonic Rs485 Ultrasonic Level Gauge 4-20ma Liquid level meter

QTLM ultraonic level sensor ideal for high-accuracy, continuous level measurement of a wide variety of liquids in storage and shipping containers requiring a non-contact measurement solution.QTLM ultraonic level meter measuring range up to 30 m.
Level Range:4-30m
Sensor:ABS/PVC/PTFE
Output: 4-20mA/HART
Power:DC24V
Accuracy:0.5%

Two wire Ultrasonic level meter with the feature of contactless and material independent, easy and flexible mounting. QTLM ultrasonic level sensor adopt temperature compensation, over voltage and over current protection, which could ensure safety use.
Range:4-30m
Application:Liquid / Solid
Sensor: ABS/PVC/PTFE
Output:4-20mA/HART
Power:DC24V
Accuracy:0.5%

Ultrasonic fuel tank level sensor is a non contact level measurement device, with over voltage, over current protection and lightning protection.
Liquid tank level sensor made up of ABS probe or PTFE probe selectable, with acid and alkali resistance and safety installed in bad environment.
Level Range:4-30m
Output: 4-20mA/HART
Power:DC24V
Accuracy:0.5%

Milk Level 4-20mA Non Contact Sanitary Ultrasonic Level Gauge is a High accuracy OEM available wastewater Level meter, top quality 4-20mA output and optional Hart Communication. This sanitary ultrasonic level transmitter is widely used on chemical tank, food industry milk level, water level etc.

Specifications:
Measuring Range: liquid: 0.2-30 m
Process Connection: G2 Thread/ M95*2.0
Energy Transducer Material: ABS, PVC, PTFE
Temperature: -40~ 75 Deg C
With automatic Temperature compensation.
Process Pressure: ¡À 0.1MPa
Precision: 0.2% of actual range
Signal output: 4-20mA (Option:HART)
Power Supply: DC20V~32V ¡Ý30mA
Mode of Indication: 4 Digit LCD

The emission angle is less than 3 ¡ã, which is suitable for narrow space or guided wave pipeline measurement
Measuring range could reach to 120M, which is suitable for the measurement of large storage tanks
Measurement dead zone is in the range of 7-8CM, suitable for the measurement of small storage tanks

The small field angle and energy concentration enhanced echo capabilities, and beneficialto avoid interference.
Minimized measuring blind spot can gain better result in better performar
High SNR, even in the case of fluctuations can result of small tank measurement.

76GHz-81GHz FM wave radar
5GHz ultra-large FM scanning frequency width, wide application
Support standard HART, RS485 / MODBUS bus protocol
Support operation mode such as upper computer setting software, tank side table, etc.
24VDC power supply
Simple installation structure, adapt to various installation forms on site

Ultrasonic level transmitters are with the feature of non-contact and maintenance-free, a cost-effective and reliable solution for liquid, solid level measurments. QTLM ultrasonic level meters are with humanized LCD show window which is easy to debug, observe and installed conveniently.
Range:4-30m
Application:Liquid / Solid
Sensor: ABS/PVC/PTFE
Output:4-20mA/HART
Power:DC24V
Accuracy:0.5%

QTLM 4-20mA ultrasonic level sensor is a kind of continuous measurement of fluids that do not contain foam, vapors, fumes or gases. Support analog and HART communication, which is widely used in water, fuel tank, food tank, solid level application. Ultrasonic level meters are with the ability to provide critical data of processes through PLC control device.
Range:4-30m
Application:Liquid / Solid
Sensor: ABS/PVC/PTFE
Output:4-20mA/HART
Power:DC24V
Accuracy:0.5%

Two wire Ultrasonic level meter is a popular field-proven level measuring device in more than hundreds applications worldwide. QTLM Ultrasonic levle meter is a stable measurement device, which will not influenced by the measuring medium properties. Integrated temperature compensation improves accuracy with analog and HART communication.
Range:4-30m
Application:Liquid / Solid
Sensor: ABS/PVC/PTFE
Output:4-20mA/HART
Power:DC24V
Accuracy:0.5%

Ultrasonic level tank meter is a very popular model in sewage treatment, paper pulp, urban water supply etc. QTLM Ultrasonic level meter could be easily configured by button and provide accurate real-time measurement. Adopt advanced terminal, to ensure that wiring will not loose.
Range:4-30m
Application:Liquid / Solid
Sensor: ABS/PVC/PTFE
Output:4-20mA/HART
Power:DC24V
Accuracy:0.5%

Water tank fuel oil level sensor provide reliable, cost effective continuous measurement of fluids that do not contain foam, vapors, fumes or gases.
Ultrasonic level tank meters are suitable for use in plastic, metal or concrete tanks etc. Integrated temperature compensation improves accuracy, with built-in 4-20mA and HART communication which support for convenient operation and control.
Range:4-30m
Application:Liquid / Solid
Sensor: ABS/PVC/PTFE
Output:4-20mA/HART
Power:DC24V
Accuracy:0.5%

Emission frequency: 76GHz~81GHz
Measurement range:0.1 m ~30m
Measurement accuracy: ¡À1mm
Beam angle: 6¡ã
Power supply range: 9~24 VDC
Communication mode: TTL/NB/485
Operating temperature: -40~85¡æ
Housing material: Aluminum alloy
Antenna type: Lens antenna

76-81 GHZ frequency modulation wave FMCW radar products (also called a millimeter wave radar), because it USES higher than Ku band radar frequency millimeter wave band, the remote target detection, strong smoke dust environment.

QTLM series Ultrasonic level meter is microprocessor controlled digital level meter. Ultrasonic pulses generated by the sensor (transducer) emitted in the measurement, the surface acoustic wave after reflection by the liquid receiving same sensor or an ultrasonic receiver, by a piezoelectric crystal or a magnetostrictive device into an electrical signal by transmitting and receiving sound waves to calculate the time between the sensor surface to the distance measured liquid. QTLM series Ultrasonic level meter adopt Intellectual signal treatment technology, guarantee that the instrument meets various kinds of operating occasion.
Level Range:4-30m
Sensor:ABS/PVC/PTFE
Output: 4-20mA/HART
Power:DC24V
Accuracy:0.5%

PTFE Liquid Level Sensor High accuracy Ultrasonic Level Meter is microprocessor controlled digital level instrument, a good choice of Oil Diesel Fuel Liquid Level Meter. Ultrasonic pulses generated by the sensor (transducer) sent in the measurement, the surface acoustic wave after reflection by the liquid or receiving the same ultrasonic receiver transducer.

Specifications:
Measuring Range: liquid: 0.2-30 m
Process Connection: G2 Thread/ M95*2.0
Energy Transducer Material: ABS, PVC, PTFE
Temperature: -40~ 75 Deg C
With automatic Temperature compensation.
Process Pressure: ¡À 0.1MPa
Precision: 0.2% of actual range
Signal output: 4-20mA (Option:HART)
Power Supply: DC20V~32V ¡Ý30mA
Mode of Indication: 4 Digit LCD

Small beam angle , the energy can be concentrated, enhance the ability of echo and to avoid interference.
Antenna is in small size,easy to install.
A shorter wavelength, the reflection of solid surface inclination is better.
Good working performance in serious dust solid environment.
Smaller measuring blind area,measuring result will be more accurate.
No corrosion,no pollution,friendly to human and environment

This top quality water level measuring PTFE Liquid Level Sensor is instrument of measured water or material level; This Ultrasonic Level Meter Sensor is a digital level meter with high- performance microprocessor to process signals; It is non-contact, high reliability, cost-effective, easy to install and maintain.

Specifications:
Measuring Range: liquid: 0.2-30 m
Process Connection: G2 Thread/ M95*2.0
Energy Transducer Material: ABS, PVC, PTFE
Temperature: -40~ 75 Deg C
With automatic Temperature compensation.
Process Pressure: ¡À 0.1MPa
Precision: 0.2% of actual range
Signal output: 4-20mA (Option:HART)
Power Supply: DC20V~32V ¡Ý30mA
Mode of Indication: 4 Digit LCD

Magnetic level gauge work on the principle of buoyancy, the float moves up and down with the rise and fall of the liquid level in the measuring tube, therefore the level in the measuring chamber will be the same as the level in the silo/vessel. The measuring chamber is fitted with a float, which has a magnet inside.
Measuring range: 300¡«15000mm
Measurement accuracy: ¡À5mm or ¡À10mm
Working pressure: 1.0, 1.6, 2.5, 4.0, 6.4 ,10,16.0MPa
Working temperature: ¡Ü550¡æ
Medium viscosity: ¡Ü0.02Pa.S
Output signal: two-wire system 4¡«20mADC or HART protocol or four-wire system 485 digital output
Explosion-proof grade: Exdll CT6
Protection level: IP66

80G radar level meter is FMCW radar operating at 76-81 GHz, which has a maximum measuring range of 120m and a minimum blind zone of 8cm. It supports 4-wire and 2-wire applications. Higher operating frequency and shorter wavelength make it ideal for solid applications,

Magnetic flap level gauge is suitable for the liquid level detection in the application of industrial production, various pressure-bearing (or open) liquid storage equipment such as towers, cylinders, tanks, spherical vessels and boilers.
Measuring range: 300¡«15000mm
Measurement accuracy: ¡À5mm or ¡À10mm
Working pressure: 1.0, 1.6, 2.5, 4.0, 6.4 ,10,16.0MPa
Working temperature: ¡Ü550¡æ
Medium viscosity: ¡Ü0.02Pa.S
Output signal: two-wire system 4¡«20mADC or HART protocol or four-wire system 485 digital output
Explosion-proof grade: Exdll CT6
Protection level: IP66

PTFE Liquid level Sensor Liquid Tank Ultrasonic Level Gauge is for continuous non-contact level measurement in liquids and solids. It consists of probe and host, both of which are plastic leak-proof structure. Solar power systems can be the perfect solution for level measurement equipment in remote locations.

Specifications:
Measuring Range: liquid: 0.2-30 m
Process Connection: G2 Thread/ M95*2.0
Energy Transducer Material: ABS, PVC, PTFE
Temperature: -40~ 75 Deg C
With automatic Temperature compensation.
Process Pressure: ¡À 0.1MPa
Precision: 0.2% of actual range
Signal output: 4-20mA (Option:HART)
Power Supply: DC20V~32V ¡Ý30mA
Mode of Indication: 4 Digit LCD

QTLM series non contact ultrasonic level meter use the time of flight measuring principle, the sensor emits ultrasonic pulses in the direction of the medium, the pulses bounce from the surface of the medium and then reflects the ultrasonic pulses back. Ultrasonic fuel tank level sensor adopt Intellectual signal treatment technology, guarantee that the instrument meets various kinds of operating occasion.
Range:4-30m
Application:Liquid / Solid
Sensor: ABS/PVC/PTFE
Output:4-20mA/HART
Power:DC24V
Accuracy:0.5%

Water tank fuel oil level sensors are with the feature of non-contact and maintenance-free. QTLM ultrasonic level gauge is a cost-effective and reliable solution for liquid, solid level measurments. Q&Tdesign with humanized LCD show window which is easy to debug, observe and installed conveniently.
Range:4-30m
Application:Liquid / Solid
Sensor: ABS/PVC/PTFE
Output:4-20mA/HART
Power:DC24V
Accuracy:0.5%

QTLM Series Ultrasonic level meters are widely used in liquid or solid application. Ultrasonic level transmitter support 4-20mA two wire output and HART communication, which is very popular and convenience for user’s system, with the ability to control and monitor.
Range:4-30m
Application:Liquid / Solid
Sensor: ABS/PVC/PTFE
Output:4-20mA/HART
Power:DC24V
Accuracy:0.5%

Ultrasonic level transmitter is a kind of continuous level measurement device. Widely used for liquid, slurry and solid level tank, with the feature of Non-contact and maintenance-free. Ultrasonic level gauge adopt temperature compensation technology which could make level measurement more accurate and stable.
Range:4-30m
Application:Liquid / Solid
Sensor: ABS/PVC/PTFE
Output:4-20mA/HART
Power:DC24V
Accuracy:0.5%

Q&T PTFE Liquid Level Sensor PVDF Sensor ultrasonic level transmitter is a digital level meter with high- performance microprocessor to process signals; It meets the requirements of material level without the contact. It can be widely used for level measurement of municipal river, urban groundwater level, sewage treatment station, water works, etc.

Specifications:
Measuring Range: liquid: 0.2-30 m
Process Connection: G2 Thread/ M95*2.0
Energy Transducer Material: ABS, PVC, PTFE
Temperature: -40~ 75 Deg C
With automatic Temperature compensation.
Process Pressure: ¡À 0.1MPa
Precision: 0.2% of actual range
Signal output: 4-20mA (Option:HART)
Power Supply: DC20V~32V ¡Ý30mA
Mode of Indication: 4 Digit LCD

Ultrasonic fuel tank level sensor is a cost-effective and reliable solution for liquid and solid level tanks. QTLM model Ultrasonic level meter is consisted of sensor and transmitter. The transmitter adopt user-friendly design, support analog and HART communication,
Range:4-30m
Application:Liquid / Solid
Sensor: ABS/PVC/PTFE
Output:4-20mA/HART
Power:DC24V
Accuracy:0.5%

Non contact ultrasonic level meter is a recommend choice for different level applications which require low cost, non-contact level measurement. QTLM Ultrasonic level meters are with the ability of being easily connected into control systems.
Range:4-30m
Application:Liquid / Solid
Sensor: ABS/PVC/PTFE
Output:4-20mA/HART
Power:DC24V
Accuracy:0.5%

Ultrasonic level gauge is digital type non contact level measurement for liquid, solid etc. It is highly reliable and cost-effective level measuring instrument with the feature of easy installed and maintained.
Ultrasonic level tank meter could meet most of the level measurement requirements. Material. It support various connections like thread or flange connection type which is much easier for user.
Range:4-30m
Output:4-20mA/HART
Connection:Thread/Flange
Power:DC24V
Accuracy:0.5%
Protection:IP65