Factory Price 4-20mA Non Contact Water Tank Fuel OIl Ultrasonic Liquid Level Sensor Transmitter Meter

Emission frequency: 76GHz~81GHz
Measurement range:0.1 m ~30m
Measurement accuracy: ¡À1mm
Beam angle: 6¡ã
Power supply range: 9~24 VDC
Communication mode: TTL/NB/485
Operating temperature: -40~85¡æ
Housing material: Aluminum alloy
Antenna type: Lens antenna

76GHz-81GHz FM wave radar
5GHz ultra-large FM scanning frequency width, wide application
Support standard HART, RS485 / MODBUS bus protocol
Support operation mode such as upper computer setting software, tank side table, etc.
24VDC power supply
Simple installation structure, adapt to various installation forms on site

Water tank fuel oil level sensors are with the feature of non-contact and maintenance-free. QTLM ultrasonic level gauge is a cost-effective and reliable solution for liquid, solid level measurments. Q&Tdesign with humanized LCD show window which is easy to debug, observe and installed conveniently.
Range:4-30m
Application:Liquid / Solid
Sensor: ABS/PVC/PTFE
Output:4-20mA/HART
Power:DC24V
Accuracy:0.5%

Ultrasonic level meter is a kind of non contact level measurement device which adopt Intellectual signal treatment technology. QTLM water tank level meter guarantee that the meter meets various kinds of operating occasion. Especially for waste water treatment, paper pulp, urban water supply etc.
Range:4-30m
Application:Liquid / Solid
Sensor: ABS/PVC/PTFE
Output:4-20mA/HART
Power:DC24V
Accuracy:0.5%

Ultrasonic fuel tank level sensor adopt ultrasonic technology is a good choice for level applications that require low cost, non-contact liquid slurry and solid level measurement. Especially for sewage treatment, paper pulp, urban water supply etc.
Ultrasonic level transmitter support 4-20mA two wire and HART communication, which is very convenient for customer’s application.
Range:4-30m
Output:4-20mA/HART
Connection:Thread/Flange
Power:DC24V
Accuracy:0.5%
Protection:IP65

Two wire Ultrasonic level meter sensor emits the ultrasonic wave to measure the distance by measuring the time between the wave emission and reception. Ultrasonic level tank meter is a cost-effective and reliable solution. For measuring liquid and solid level at ranges of up to 30 meters. It support direct reading on the LCD display, and output 4-20mA and HART.
Range:4-30m
Application:Liquid / Solid
Output:4-20mA/HART
Power:DC24V
Accuracy:0.5%

QTLM series Ultrasonic level meter is a non-contact, low-cost and easy-to-install level gauge. It applies advanced aerospace technology to the general livelihood industry. Unlike ordinary level gauges, ultrasonic level gauges have more restrictions. The products are durable and durable, simple in appearance, single and reliable in function.It has large measuring range, high precision and low energy consumption.It widely used in liquid or solid application.
Level Range:4-30m
Sensor:ABS/PVC/PTFE
Output: 4-20mA/HART
Power:DC24V
Accuracy:0.5%

QTLM ultrasonic level sensor emits the ultrasonic wave to measure the distance by measuring the time between the wave emission and reception.The sensor fully enclosed probe,improve the intensity of the transmitted signal,integrated casting,good long-term stability.it is a cost-effective and reliable solution.Easy and flexible mounting combined with high chemical compatibility.

Level Range:4-30m
Sensor:ABS/PVC/PTFE
Output: 4-20mA/HART
Power:DC24V
Accuracy:0.5%

This top quality water level measuring PTFE Liquid Level Sensor is instrument of measured water or material level; This Ultrasonic Level Meter Sensor is a digital level meter with high- performance microprocessor to process signals; It is non-contact, high reliability, cost-effective, easy to install and maintain.

Specifications:
Measuring Range: liquid: 0.2-30 m
Process Connection: G2 Thread/ M95*2.0
Energy Transducer Material: ABS, PVC, PTFE
Temperature: -40~ 75 Deg C
With automatic Temperature compensation.
Process Pressure: ¡À 0.1MPa
Precision: 0.2% of actual range
Signal output: 4-20mA (Option:HART)
Power Supply: DC20V~32V ¡Ý30mA
Mode of Indication: 4 Digit LCD

This Non-contact High Accuracy PTFE Level sensor Sanitary Ultrasonic level Meter is a kind of non-contact, high reliability, and easy installation level measuring instrument. The Wireless Ultrasonic Liquid Tank Level Meter Sensor can be widely
applied to the water supply, food industry, chemical, electricity and oil industries.

Specifications:
Measuring Range: liquid: 0.2-30 m
Process Connection: G2 Thread/ M95*2.0
Energy Transducer Material: ABS, PVC, PTFE
Temperature: -40~ 75 Deg C
With automatic Temperature compensation.
Process Pressure: ¡À 0.1MPa
Precision: 0.2% of actual range
Signal output: 4-20mA (Option:HART)
Power Supply: DC20V~32V ¡Ý30mA
Mode of Indication: 4 Digit LCD

76-81 GHZ frequency modulation wave FMCW radar products (also called a millimeter wave radar), because it USES higher than Ku band radar frequency millimeter wave band, the remote target detection, strong smoke dust environment.

Frequency: 76GHz ~ 81GHz, 5GHz FMCW bandwidth
Measuring range: 0.3 m ~ 60m
0.08m~30m
0.6m ~ 120m
Measurement accuracy: ¡À1mm
Beam angle: 3¡ã/8¡ã
Power: 15~28VDC
Communication: MODBUS
HART/Series
Signal output: 4 ~ 20mA or RS-485

Non contact ultrasonic level meter with the features of non-contact, high reliability, cost-effective, easy to be installed and maintained. QTLM ultrasonic level gauge widely used for liquid, slurry and solid level tanks, support various connections like thread or flange connection type.
Range:4-30m
Application:Liquid / Solid
Sensor: ABS/PVC/PTFE
Output:4-20mA/HART
Power:DC24V
Accuracy:0.5%

Process pressure£º-0.1~0.5MPa
Measurement accuracy£º¡À1mm
Protection class£ºIP67
Explosion-proof grade£ºExib II CT6 Gb
Shell material£ºCast aluminum/stainless steel
Signal output£º4-20mA, HART (two-wire, four-wire), RS485 Modbus

Ultrasonic fuel tank level sensor is integrated design, with big show window of LCD which is easy to debug, observe and installed conveniently.
Ultrasonic level gauge adopt Advanced since the clamp type terminal, to ensure that wiring never loose.
Level Range:4-30m
Sensor:ABS/PVC/PTFE
Output: 4-20mA/HART
Power:DC24V
Accuracy:0.5%

Two wire Ultrasonic level meter with the feature of contactless and material independent, easy and flexible mounting. QTLM ultrasonic level sensor adopt temperature compensation, over voltage and over current protection, which could ensure safety use.
Range:4-30m
Application:Liquid / Solid
Sensor: ABS/PVC/PTFE
Output:4-20mA/HART
Power:DC24V
Accuracy:0.5%

QTLM series non contact ultrasonic level meter use the time of flight measuring principle, the sensor emits ultrasonic pulses in the direction of the medium, the pulses bounce from the surface of the medium and then reflects the ultrasonic pulses back. Ultrasonic fuel tank level sensor adopt Intellectual signal treatment technology, guarantee that the instrument meets various kinds of operating occasion.
Range:4-30m
Application:Liquid / Solid
Sensor: ABS/PVC/PTFE
Output:4-20mA/HART
Power:DC24V
Accuracy:0.5%

Emission frequency: 76GHz~81GHz
Measurement range:0.1 m ~30m
Measurement accuracy: ¡À1mm
Beam angle: 6¡ã
Power supply range: 9~24 VDC
Communication mode: TTL/NB/485
Operating temperature: -40~85¡æ
Housing material: Aluminum alloy
Antenna type: Lens antenna

Measuring Range: 70m
Frequency Range: 26GHz
Output: 4-20mA/HART
Accuracy: ¡À15mm
Process Pressure: -0.1 ~ 4 MPa
Housing material: Stainless Steel
Process connectio: Flange

The emission angle is less than 3 ¡ã, which is suitable for narrow space or guided wave pipeline measurement
Measuring range could reach to 120M, which is suitable for the measurement of large storage tanks
Measurement dead zone is in the range of 7-8CM, suitable for the measurement of small storage tanks

QTLM 4-20mA ultrasonic level sensor is a kind of continuous measurement of fluids that do not contain foam, vapors, fumes or gases. Support analog and HART communication, which is widely used in water, fuel tank, food tank, solid level application. Ultrasonic level meters are with the ability to provide critical data of processes through PLC control device.
Range:4-30m
Application:Liquid / Solid
Sensor: ABS/PVC/PTFE
Output:4-20mA/HART
Power:DC24V
Accuracy:0.5%

76-81 GHZ frequency modulation wave FMCW radar products (also called a millimeter wave radar), because it USES higher than Ku band radar frequency millimeter wave band, the remote target detection, strong smoke dust environment.

The Vertical magnetic Level Indicator is easy to read the water level; Because of the construction of the flaps, one side white and on the other red / orange it is possible to see the level over a greater distance or in darker places.
Measuring range: 300¡«15000mm
Measurement accuracy: ¡À5mm or ¡À10mm
Working pressure: 1.0, 1.6, 2.5, 4.0, 6.4 ,10,16.0MPa
Working temperature: ¡Ü550¡æ
Medium viscosity: ¡Ü0.02Pa.S
Output signal: two-wire system 4¡«20mADC or HART protocol or four-wire system 485 digital output
Explosion-proof grade: Exdll CT6
Protection level: IP66

Small beam angle , the energy can be concentrated, enhance the ability of echo and to avoid interference.
Antenna is in small size,easy to install.
A shorter wavelength, the reflection of solid surface inclination is better.
Good working performance in serious dust solid environment.
Smaller measuring blind area,measuring result will be more accurate.
No corrosion,no pollution,friendly to human and environment

Ultrasonic level transmitter is a kind of continuous level measurement device. Widely used for liquid, slurry and solid level tank, with the feature of Non-contact and maintenance-free. Ultrasonic level gauge adopt temperature compensation technology which could make level measurement more accurate and stable.
Range:4-30m
Application:Liquid / Solid
Sensor: ABS/PVC/PTFE
Output:4-20mA/HART
Power:DC24V
Accuracy:0.5%

Application: Liquid: mildly/strongly corrosive liquid
Measuring range: 30m / 100m
Process connection:Thread
Process temperature: (-40¡«90)¡æ
Process pressure: (-0.1¡«0.1)MPa
Accuracy: ¡À2mm / ¡À10mm
Antenna/Material: Lens antenna / PP or PTFE
Frequency rate: 80GHz
Explosion-proof grade: Exia IICT6 / Exd IICT6

Higher signal-to-noise ratio, almost unaffected by level fluctuations;
The measurement accuracy is millimeter-level accuracy (1mm), which can be
used for metrology-level measurement;
The measurement blind area is small (3cm), and the effect of measuring the liquid
level of small storage tanks is better.

humidity: ¡Ü95%RH
Enclosure: Aluminum alloy, stainless steel
Antenna type: Lens antenna/anti-corrosive antenna / flange isolated by quartz
Process temperature: -40~85¡æ; -40~200¡æ;
Process pressure: -0.1~2MPa
Product Size: ?100*270mm
Cable entry: M20*1.5
Protection class: IP67
Explosion-proof grade: ExdiaIICT6
Installation method: Thread or flange

QTLM Series Ultrasonic level transmitter time of flight measuring principle, the sensor emits the ultrasonic wave to measure the distance by measuring the time between the wave emission and reception. Water tank fuel oil level sensor is compact version, loop-powered 4-20mA for continuous measurement of liquid and solid tanks.
Range:4-30m
Application:Liquid / Solid
Sensor: ABS/PVC/PTFE
Output:4-20mA/HART
Power:DC24V
Accuracy:0.5%

QTLM series Ultrasonic level meter is a non-contact, high reliability, cost-effective, easy to install and maintain level measurement instruments and easily configured by menu button and could give precision and accuracy for real-time measurement. the new generation ultrasonic level meter is developed through our company¡¯s many years¡¯ efforts and our company own the completely independent property rights of it.
Level Range:4-30m
Sensor:ABS/PVC/PTFE
Output: 4-20mA/HART
Power:DC24V
Accuracy:0.5%