80ghz water-based mud acid-base liquid radar level sensor

76-81 GHZ frequency modulation wave FMCW radar products (also called a millimeter wave radar), because it USES higher than Ku band radar frequency millimeter wave band, the remote target detection, strong smoke dust environment.

Higher signal-to-noise ratio, almost unaffected by level fluctuations;
The measurement accuracy is millimeter-level accuracy (1mm), which can be
used for metrology-level measurement;
The measurement blind area is small (3cm), and the effect of measuring the liquid
level of small storage tanks is better.

Small beam angle , the energy can be concentrated, enhance the ability of echo and to avoid interference.
Antenna is in small size,easy to install.
A shorter wavelength, the reflection of solid surface inclination is better.
Good working performance in serious dust solid environment.
Smaller measuring blind area,measuring result will be more accurate.
No corrosion,no pollution,friendly to human and environment

Measuring Range: 70m
Frequency Range: 26GHz
Output: 4-20mA/HART
Accuracy: ¡À15mm
Process Pressure: -0.1 ~ 4 MPa
Housing material: Stainless Steel
Process connectio: Flange

Application: Liquid: mildly/strongly corrosive liquid
Measuring range: 30m / 100m
Process connection:Thread
Process temperature: (-40¡«90)¡æ
Process pressure: (-0.1¡«0.1)MPa
Accuracy: ¡À2mm / ¡À10mm
Antenna/Material: Lens antenna / PP or PTFE
Frequency rate: 80GHz
Explosion-proof grade: Exia IICT6 / Exd IICT6

76-81 GHZ frequency modulation wave FMCW radar products (also called a millimeter wave radar), because it USES higher than Ku band radar frequency millimeter wave band, the remote target detection, strong smoke dust environment.

The product has extremely high measurement accuracy, suitable for high-precision measurement level measurement
The product has rich echo processing algorithms and empirical data of various working conditions; it has unique advantages than other similar products in the application of extremely harsh working conditions such as strong dust, steam, or special process storage tanks with stirring and heating rods.

The antenna adopts PTFE lens, which is effective anti-corrosion and anti-hanging
material;
Support remote debugging and remote upgrade, reduce waiting time and improve
work efficiency;
It supports mobile phone Bluetooth debugging, which is convenient for
maintenance work of on-site personnel.

Process pressure£º-0.1~0.5MPa
Measurement accuracy£º¡À1mm
Protection class£ºIP67
Explosion-proof grade£ºExib II CT6 Gb
Shell material£ºCast aluminum/stainless steel
Signal output£º4-20mA, HART (two-wire, four-wire), RS485 Modbus

Frequency: 76GHz ~ 81GHz, 5GHz FMCW bandwidth
Measuring range: 0.3 m ~ 60m
0.08m~30m
0.6m ~ 120m
Measurement accuracy: ¡À1mm
Beam angle: 3¡ã/8¡ã
Power: 15~28VDC
Communication: MODBUS
HART/Series
Signal output: 4 ~ 20mA or RS-485

Frequency Range£º76~81GHz
Scope of application£ºStrong corrosive liquid level, stirring, water vapor condensation
Measuring range£º120m
Process connection£ºflange, thread
Medium temperature£º-40~120¡æ

humidity: ¡Ü95%RH
Enclosure: Aluminum alloy, stainless steel
Antenna type: Lens antenna/anti-corrosive antenna / flange isolated by quartz
Process temperature: -40~85¡æ; -40~200¡æ;
Process pressure: -0.1~2MPa
Product Size: ?100*270mm
Cable entry: M20*1.5
Protection class: IP67
Explosion-proof grade: ExdiaIICT6
Installation method: Thread or flange

Small beam angle , the energy can be concentrated, enhance the ability of echo and to avoid interference.
Antenna is in small size,easy to install.
A shorter wavelength, the reflection of solid surface inclination is better.
Good working performance in serious dust solid environment.
Smaller measuring blind area,measuring result will be more accurate.
No corrosion,no pollution,friendly to human and environment

The emission angle is less than 3 ¡ã, which is suitable for narrow space or guided wave pipeline measurement
Measuring range could reach to 120M, which is suitable for the measurement of large storage tanks
Measurement dead zone is in the range of 7-8CM, suitable for the measurement of small storage tanks

The product has a wealth of echo processing algorithms and empirical data of
various working conditions; it is used for extremely harsh working conditions such as
strong dust, steam, or special process storage tank applications such as stirring and
heating rods, which are not available in other similar products unique advantage.

The beam angle can reach 3¡ã, and the energy is more focused, effectively
avoiding false echo interference;
High frequency signal, can effectively measure the level of medium with low
dielectric constant (¦Å¡Ý1.5);
Strong anti-interference, almost unaffected by dust, steam, temperature and
pressure changes;

humidity: ¡Ü95%RH
Enclosure: Aluminum alloy, stainless steel
Antenna type: Lens antenna/anti-corrosive antenna / flange isolated by quartz
Process temperature: -40~85¡æ; -40~200¡æ;
Process pressure: -0.1~2MPa
Product Size: ?100*270mm
Cable entry: M20*1.5
Protection class: IP67
Explosion-proof grade: ExdiaIICT6
Installation method: Thread or flange

80G radar level meter is FMCW radar operating at 76-81 GHz, which has a maximum measuring range of 120m and a minimum blind zone of 8cm. It supports 4-wire and 2-wire applications. Higher operating frequency and shorter wavelength make it ideal for solid applications,

76GHz-81GHz FM wave radar
5GHz ultra-large FM scanning frequency width, wide application
Support standard HART, RS485 / MODBUS bus protocol
Support operation mode such as upper computer setting software, tank side table, etc.
24VDC power supply
Simple installation structure, adapt to various installation forms on site

The emission angle is less than 3 ¡ã, which is suitable for narrow space or guided wave pipeline measurement
Measuring range could reach to 120M, which is suitable for the measurement of large storage tanks
Measurement dead zone is in the range of 7-8CM, suitable for the measurement of small storage tanks

Application: Liquid: mildly/strongly corrosive liquid
Measuring range: 30m / 100m
Process connection:Thread
Process temperature: (-40¡«90)¡æ
Process pressure: (-0.1¡«0.1)MPa
Accuracy: ¡À2mm / ¡À10mm
Antenna/Material: Lens antenna / PP or PTFE
Frequency rate: 80GHz

80G radar level meter is FMCW radar operating at 76-81 GHz, which has a maximum measuring range of 120m and a minimum blind zone of 8cm. It supports 4-wire and 2-wire applications. Higher operating frequency and shorter wavelength make it ideal for solid applications,

Frequency Range£º76~81GHz
Scope of application£ºStrong corrosive liquid level, stirring, water vapor condensation
Measuring range£º120m
Process connection£ºflange, thread
Medium temperature£º-40~120¡æ

The small field angle and energy concentration enhanced echo capabilities, and beneficialto avoid interference.
Minimized measuring blind spot can gain better result in better performar
High SNR, even in the case of fluctuations can result of small tank measurement.

Process pressure£º-0.1~0.5MPa
Measurement accuracy£º¡À1mm
Protection class£ºIP67
Explosion-proof grade£ºExib II CT6 Gb
Shell material£ºCast aluminum/stainless steel
Signal output£º4-20mA, HART (two-wire, four-wire), RS485 Modbus

80G radar level meter is FMCW radar operating at 76-81 GHz, which has a maximum measuring range of 120m and a minimum blind zone of 8cm. It supports 4-wire and 2-wire applications. Higher operating frequency and shorter wavelength make it ideal for solid applications,

humidity: ¡Ü95%RH
Enclosure: Aluminum alloy, stainless steel
Antenna type: Lens antenna/anti-corrosive antenna / flange isolated by quartz
Process temperature: -40~85¡æ; -40~200¡æ;
Process pressure: -0.1~2MPa
Product Size: ?100*270mm
Cable entry: M20*1.5
Protection class: IP67
Explosion-proof grade: ExdiaIICT6
Installation method: Thread or flange

Measuring Range:100m
Frequency Range: 80GHz
Output: 4-20mA/HART
Accuracy: ¡À15mm
Process Pressure: -0.1 ~ 4 MPa
Housing material: Stainless Steel
Process connectio: Flange

Frequency: 76GHz ~ 81GHz, 5GHz FMCW bandwidth
Measuring range: 0.3 m ~ 60m
0.08m~30m
0.6m ~ 120m
Measurement accuracy: ¡À1mm
Beam angle: 3¡ã/8¡ã
Power: 15~28VDC
Communication: MODBUS
HART/Series
Signal output: 4 ~ 20mA or RS-485

Steam flowmeter is applicable for liquid or gas measurement,the calibration is different for vortex air flow meter and liquid vortex flow meter. Size: DN15-DN6000; Measured medium: liquid,gas,steam; Medium Temp: -40¡æ~250¡æ,-40¡æ~350¡æ,
Accuracy: ¡À1.0 % (Flange / wafer / thread / tri-clamp; ¡À1.5 % (Insertion type)
Specifications: DN100-2000 (Insertion),
Material: SS304(Standard),SS316(Optional) Signal Output: 4-20mA,Pulse Communication: RS485 MODBUS or HART